NEC Univerge SV9100 - Page 632

632
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
13-04-01
Speed Dialing Number and Name – Speed
Dialing Data
This program stores Speed Dial data into the
Speed Dial areas, and defines the Speed Dial
names.
Maximum of 24 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer
Supervision - ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
13-04-02
Speed Dialing Number and Name – Name
Assign a name to each System Speed Dial bin.
Maximum of 12 Characters (Use
dial pad to enter name).
No Setting
13-04-11
Speed Dialing Number and Name –
Automatic Access to Voice Mail by Caller ID
Per Speed dial Bin No. (0000-9999), set the VM
BOX number (0 ~ 896). Incoming Caller ID
number will be checked against Speed Dial
data (Program 13-04-01). From matched Speed
Dial Bin No, system then finds the associated
VM Box number with this Program.
Mailbox Number 0 ~ 896,
900 ~ 931
0
14-01-22
Basic Trunk Data Setup – Caller ID to Voice
Mail
Enable/Disable the system ability to send the
Caller ID digits to voice mail.
Trunks 1 ~ 400
0 = Disable
1 = Enable
0
15-22-01
Mobile Extension Setup – Mobile Extension
Target Setup
For each Mobile Extension number, select the
Abbreviated Dial bin number to be associated
with it.
When using this feature with Mobile Extension,
set the associated VM Box number in Program
13-04-11. The incoming Extension number will
be checked with Program15-22-01. From
matched Speed Dial Bin No, system finds the
VM Box number with Program 13-04-11.
0 ~ 9999
(0 = No setting
1 ~ 9999 = target of mobile
extension)
0
22-02-01
Incoming Call Trunk Setup
Assign the incoming trunk type for each trunk.
Incoming Type for Day/Night
Mode (1 ~ 8):
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
0