NEC Univerge SV9100 - Page 675

675
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
11-11-13
Service Code Setup (for Setup/Entry
Operation) – Display Language Selection for
Multiline Terminal
If needed, redefine the service code used to
select the language for display multiline
terminals.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
778
11-11-68
Service Code Setup (for Setup/Entry
Operation) – IntraMail Language Selection
for own Extension
This setting is needed if the dial access code to
this feature is desired.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
No Setting
11-11-69
Service Code Setup (for Setup/Entry
Operation) – IntraMail Language Selection
for Specific Extension
This setting is needed if the dial access code to
this feature is desired.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
No Setting
20-13-53
Class of Service Options (Supplementary
Service) – Language Selection for Specific
Extension
This setting must be Enabled (1) for a
telephones Class of Service for this feature to
function.
0 = Disabled
1 = Enabled
0