NEC Univerge SV9100 - Page 717

717
Program
Number
Program Name/Description
Input Data
Default
24-09-03
Call Forward Split Settings - Intercom Call
Forwarding Destination for Both ring, All
Call, No Answer
Assign Intercom Call Forwarding Destination
for ring, all call and no answer.
1 ~ 9, 0, #, *, R, @
Maximum of 24 digits
No Setting
24-09-04
Call Forward Split Settings – CO Call
Forwarding Busy Destination
Assign CO Call Forwarding for busy
destinations.
1 ~ 9, 0, #, *, R, @
Maximum of 24 digits
No Setting
24-09-05
Call Forward Split Settings – Intercom Call
Forwarding Busy Destination
Assign Intercom Call Forwarding for busy
destinations.
1 ~ 9, 0, #, *, R, @
Maximum of 24 digits
No Setting
24-09-06
Call Forward Split Settings – Call
Forwarding Destination for CTX/PBX for All
Call, No Answer
Assign Call Forwarding for CTX/PBX all call, no
answer destinations.
1 ~ 9, 0, #, *, R, @
Maximum of 24 digits
No Setting
24-09-07
Call Forward Split Settings – Call
Forwarding Destination for CTX/PBX for
Busy
Assign Call Forwarding destinations for busy
CTX/PBX calls.
1 ~ 9, 0, #, *, R, @
Maximum of 24 digits
No Setting
84-24-01
DT800/DT700 Multiline CODEC Information
Basic Setup – Number of G.711 Audio
Frames
Input the amount of audio in the packets when
using the G.711 Codec.
This should be set to 20ms (2).
1 = 10ms
2 = 20ms
3 = 30ms
4 = 40ms
2
84-24-28
DT800/DT700 Multiline CODEC Information
Basic Setup – Audio Capability Priority
Set voice (RTP packet) encoding parameters.
The ML440 only supports G.711.
0 = G.711_PT
2 = G.729_PT
0
84-26-01
IPL Basic Setup – IP Address
Assign the IP address for each DSP on the
GPZ-IPLE.
xxx.xxx.xxx.xxx
172.16.0.20
84-26-02
IPL Basic Setup – RTP Port Number
Assign the RTP port number to be used for
each DSP on the GPZ-IPLE.
Only even numbered ports are supported.
0 ~ 65534
10020
84-26-03
IPL Basic Setup – RTCP Port Number (RTP
Port Number + 1)
Define the TCP port number for RTCP to use
for each DSP.
0 ~ 65534
10021
Operation
Refer to the UNIVERGE SV9100 IP-DECT Customer Engineer Manual for additional information. For specific
handset information, refer to the following:
❍ ML440 End User Guide
❍ G266 and G566 Handsets User Guide