NEC Univerge SV9100 - Page 73

73
Program
Number
Program Name/Description
Input Data
Default
26-03-01
ARS Dial Treatments – Treatment Code
Assign the Dial Treatments (1 ~ 15) for
automatic ARS dialing translation. Assign Dial
Treatments to Service Numbers (Trunk Groups)
in Program 26-02. The ARS Dial Treatment
options are:
3 - Delete the NPA if dialed as part of the initial
call. This requires at least eight digits in the
ARS table (Program 26-02-01).
2 - Delete the leading digit if dialed as part of
the initial call. This requires at least eight digits
in the ARS table (Program 26-02-01).
1 - Add a leading 1 if not dialed as part of the
initial call. This requires at least eight digits in
the ARS table (Program 26-02-01).
INPA - Insert the NPA specified by NPA.
DNN - Outdial the NN number of digits or
execute the code that follows. For example,
D041234 out-dials 124. Valid entries are 0 ~ 9,
#, *, Wnn (wait nn seconds) and P (pause).
Each digits code counts as a digit. So for
example, if a P was added for a pause, the
entry would look like: D05P1234. This Dial
Treatment can only be added from telephone
programming.
Wnn - Wait nn seconds.
P - Pause in analog trunk.
R - Redial the initially dialed number, including
any modifications.
E - End of Dial Treatment. All Dial Treatments
must end with the E code.
X - When ARS is enabled, X must be entered in
the Dial Treatment for the system to output the
extension number of the call originator to the
black box for the E911 feature.
Maximum of 24 characters
No Setting
26-04-01
ARS Class of Service
Set an extension ARS Class of Service
(0 ~ 16). Automatic Route Selection (ARS) uses
ARS Class of Service when determining how to
route extension calls.
Day/Night Mode: 1 ~ 8
Class = 0 ~ 16
0
26-11-01
Transit Network ID Table – Transmit Network
ID (Carrier ID)
Enter the Transit Network Selection information
element to be added to an ARS call using an
ISDN trunk. This information element identifies
a requested transit network.
Four fixed digits
0000 ~ 9999
No Setting