NEC Univerge SV9100 - Page 742

742
Program
Number
Program Name/Description
Input Data
Default
10-12-09
GCD-CP10 Network Setup – IP Address
Assign the IP Address for the VoIPDB. If a
VoIPDB is installed in the system it is
recommended to set Program 10-12-01 to
0.0.0.0 and all connections to the system will be
made through the VoIPDB.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
172.16.0.10
10-12-10
GCD-CP10 Network Setup – Subnet Mask
Define the Media Gateway Subnet Mask
Address.
128.0.0.0 | 192.0.0.0 | 224.0.0.0
|240.0.0.0 | 248.0.0.0 | 252.0.0.0
|254.0.0.0 | 255.0.0.0
|255.128.0.0 | 255.192.0.0
|255.224.0.0 | 255.240.0.0
|255.248.0.0 | 255.252.0.0
|255.254.0.0 | 255.255.0.0
|255.255.128.0 | 255.255.192.0
|255.255.224.0 | 255.255.240.0
|255.255.248.0 | 255.255.252.0
|255.255.254.0 | 255.255.255.0
|255.255.255.128
|255.255.255.192
|255.255.255.224
|255.255.255.240
|255.255.255.248
|255.255.255.252
|255.255.255.254
|255.255.255.255
255.255.0.0
10-12-11
GCD-CP10 Network Setup – NIC Setup
Define the LAN interface Speed and Mode of
the VoIP Application supported.
IPLE daughter board does not support half
duplex connection.
0 = Auto Detect
1 = 100Mbps, Full Duplex
3 = 10Mbps, Full Duplex
5 = 1Gbps, Full Duplex
0
10-33-02
SIP Registar/Proxy Information Basic Setup
– Authentication Mode
When connecting STD SIP Terminal via NAT,
this option must be enabled to prohibit illegal
SIP phone registration.
0 = Disable
1 = Enable
0
10-33-05
SIP Registar/Proxy Information Basic Setup
– NAT Mode
When system controls remote SIP phone via
NAT router, set this program to 1 = Enable.
0 = Disable
1 = Enable
0
10-37-01
UPnP Setup – UPnP Mode
Enable/Disable UPnP.
0 = Disable
1 = Enable
0