NEC Univerge SV9100 - Page 751

751
Program
Number
Program Name/Description
Input Data
Default
22-02-01
Incoming Call Trunk Setup
Assign the incoming trunk type for each trunk.
Trunks 1 ~ 400
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
0
44-02-01
Dial Analysis Table for ARS/F-Route Access
– Dial
Set the number of digits to be analyzed by the
system for ARS routing.
Maximum of eight digits (Use
line key 1 for a ‘Don’t Care’ digit,
@).
No Setting
44-02-02
Dial Analysis Table for ARS/F-Route Access
– Service Type
Set the Service Type (0 ~ 3) for the Pre-
Transaction Table for selecting ARS/F-Route.
0 = No Setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension Analyze
Table (Option)
0
44-02-03
Dial Analysis Table for ARS/F-Route Access
– Additional Data
If a Service Type is selected in Program
44-02-02, set the additional data, if required, for
the Pre-Transaction Table for selecting ARS/
F-Route (24 digits max: 1 ~ 9, 0 * #, @). To
enter a wild card/don’t care digit, press Line
Key 1 to enter an @.
1 = Delete Digit = 0 ~ 255
(255: Delete All Digits)
2 = 0 ~ 500
(0 = No Setting)
3 = Dial Extension Analyze
Table Number = 0 ~ 4
(0 = No Setting)
0
44-05-01
ARS/F-Route Table – Trunk Group Number
Select the trunk group number to be used for
the outgoing ARS call.
0 ~ 100, 255
0 = No Setting
255 = Extension Call
0
44-05-09
ARS/F-Route Table – Maximum Digit
Input the maximum number of digits to send
when using the F-Route.
0 ~ 24
0
84-01-02
H.323 Trunk Basic Information Setup –
Number of G.711 audio frames
Define the number of G.711 Audio Frames.
1 ~ 4
3
84-01-03
H.323 Trunk Basic Information Setup – G.711
VAD mode
Enable/Disable the G.711 VAD mode for H.323.
0 = Disable
1 = Enable
0
84-01-04
H.323 Trunk Basic Information Setup – G.711
Type
Define the G.711 type for H.323.
0 = A-law
1 = -law
1