NEC Univerge SV9100 - Page 762

762
Related Features
None
Guide to Feature Programming
IP Trunk – (SIP) Session Initiation Protocol:
Program
Number
Program Name/Description
Input Data
Default
10-12-03
GCD-CP10 Network Setup – Default
Gateway
Assign the default gateway IP address for the
GCD-CP10.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.254.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
10-12-05
GCD-CP10 Network Setup – NIC Interface
Set up the NIC Interface.
0 = Auto Detect
1 = 100Mbps, Full Duplex
2 = 100Mbps, Half Duplex
3 = 10Mbps, Full Duplex 4
= 10Mbps, Half Duplex 5
= 1Gbps, Full Duplex
0
10-12-07
GCD-CP10 Network Setup – NAPT Router IP
Address
(Default Gateway [WAN])
Define the IP Address of the WAN side of the
router.
Only used when Program 10-20-21 is enabled.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
10-12-08
GCD-CP10 Network Setup – ICMP Redirect
When receiving ICMP redirect messages, this
determines if the IP Routing Table updates
automatically or not.
0= (Enable)
1= (Disable)
0
10-12-09
GCD-CP10 Network Setup – IP Address
Set IP address for GPZ-IPLE.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
172.16.0.10