NEC Univerge SV9100 - Page 82

82
Program
Number
Program Name/Description
Input Data
Default
26-02-02
Dial Analysis Table for ARS – ARS Service
Type
For each Dial Analysis Table (1 ~ 2000), select
0 for no ARS, 1 for Service Type 1 – Route to
Trunk Group Number to have the number route
to a trunk group [Refer to Program 26-02-03] or
2 for Service Type 2 – F-Route Selected to
have the dialed number controlled by the
F-Route table. If Service Type 2 is selected and
F-Route operation is on, the F-Route table used
is determined by Program 44-04. If F-Route
operation is off, the routing is determined by
Program 44-05.
0 = No Service (Call Restricted)
1 = Route to Trunk Group
2 = Select F-Route Access
0
26-02-03
Dial Analysis Table for ARS – Additional
Data/Service Number
For each Dial Analysis Table (1 ~ 2000), if
Service Type 1 was selected in Program
26-02-02, enter the trunk group number (0
~ 100, 0 = No Route).
If Service Type 1 (in 26-02):
Select Trunk Group Number
0 ~ 100, (Trunk Group Number 0
= No Route)
101 ~ 150 (Networking ID)
If Service Type 2 (in 26-02):
F-Route Time Schedule Not
Used = 0 ~ 500
(F-Route Table Number).
F-Route Time Schedule Used =
0 ~ 500
(F-Route Selection Number)
0
26-02-04
Dial Analysis Table for ARS – ARS Class of
Service
For each Dial Analysis Table (1 ~ 2000), set the
Automatic Route Selection (ARS) (ARS) Class
of Service (0 ~ 16).
0 ~ 16
0
26-02-05
Dial Analysis Table for ARS – Dial Treatment
for ARS
For each Dial Analysis Table (1 ~ 2000), set the
Automatic Route Selection (ARS) Dial
Treatment (0 ~ 15) to be used.
0 ~ 15
0
26-02-07
Dial Analysis Table for ARS – Network
Specified Parameter Table
For each Dial Analysis Table (1 ~ 2000), set the
Automatic Route Selection (ARS) (ARS)
Network Specified Parameter Table (0 ~ 16) to
be used.
0 ~ 16
0