NEC Univerge SV9100 - Page 91

91
Program
Number
Program Name/Description
Input Data
Default
20-13-17
Class of Service Options (Supplementary
Service) – Barge-In Tone/Display (Intrusion
Tone)
Turn Off or On the Barge-In (Intrusion) Tone. If
disabled, this also turns off the Barge-In display
at the called extension.
0 = Off
1 = On
COS 1 ~ 15 = 1
20-13-32
Class of Service Options (Supplementary
Service) – Deny Multiple Barge-Ins
Allow (1)/Deny (0) an extension user ability to
have multiple users Barge-In to their
conversation.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-14-11
Class of Service Options for DISA/E&M –
DISA/Tie Trunk Barge-In
Enable (1)/Disable (0) a DISA or tie trunk user
from using the Barge-In feature.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-18-07
Service Tone Timers – Intrusion Tone
Repeat Time
After a user barges in, the system repeats the
Barge-In tone after this time.
0 ~ 64800 seconds
0
21-01-03
System Options for Outgoing Calls – Trunk
Interdigit Time (External)
Program the time an extension must wait
before using the Barge-In feature can be used
on a call (this timer waits until it expires before
putting a call in a talk state). This time also
affects Voice Over.
0 ~ 64800 seconds
5
Operation
To Barge-In after calling a busy extension:
The time in Program 21-01-03 must expire before you can Barge-In.
1. Call a busy extension.
2. Press Barge-In key (Program 15-07-01 or SC 851: 34).
To Barge-In without first calling the busy extension:
1. Pick up the handset or press Speaker.
2. Dial 810.
- OR -
Press Barge-In key (Program 15-07-01 or SC 851: 34).
3. Dial busy extension.
 The extension user hears a warning tone.
 The DISA user is rerouted to the defined ring group.
 The Tie Line user hears a busy tone.
- OR -