NEC Univerge SV9100 - Page 921

921
Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1
Enter characters:
1 @ [ ¥ ] ^ _
`
{
|
}
Æ
¨
Á
À
Â
Ã
Ç
É
Ê
ì
ó
2
Enter characters: A-C, a-c, 2.
3
Enter characters: D-F, d-f, 3.
4
Enter characters: G-I, g-i, 4.
5
Enter characters: J-L, j-l, 5.
6
Enter characters: M-O, m-o, 6.
7
Enter characters: P-S, p-s, 7.
8
Enter characters: T-V, t-v, 8.
9
Enter characters: W-Z, w-z, 9.
0
Enter characters:
0 ! “ # $
%
&
’ (
) ô Õ ú
ä
ö ü 

*
Enter characters:
* + , - . /
:
;
<
=
>
?
π Σ Ω
∞ ¢
£
#
# = Accepts an entry (only required if two letters on the same key are needed – ex:
TOM). Pressing # again = Space. (In system programming mode, use the right
arrow Softkey instead to accept and/or add a space.)
Feature
Clear the character entry one character at a time (when using service code or function
key).
Recall
Clear the character entry one character at a time (when in telpro).
Hold (Telpro Mode Only)
Clear all the entries from the point of the flashing cursor and to the right.