927
Class of Service Options (Administrator
Level) – Manual Night Service Enabled
Turn Off or On an extension user ability to
manually Switch the Night Mode (Service Code
718). This option must be enabled for an
extension to display the Night indication.
COS 1 ~ 14 = 0
COS 15 = 1
Class of Service Options (Answer Service) –
Automatic Off-Hook Answer
Turn Off or On an extension user ability to use
Universal Auto Answer (no service code
required).
Incoming Call Trunk Setup
Assign the incoming trunk type for each trunk.
There is one item for each Night Service Mode
(1 ~ 8).
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
Incoming Extension Ring Group
Assignment
To have trunks ring extensions during the
different Night Service modes (for ANA), assign
extensions to Ring Groups. For each extension
in the Ring Groups (1 ~ 100), indicate in
Program 22-06-01 if trunk should Ring (1) or
Not Ring (0).
Extensions
101 ~ 108 (first
eight ports) ring
for incoming
Ring Group 1
calls. No other
extensions ring
for incoming
Ring Group 1
calls.
Incoming Trunk Ring Group Assignment
To have trunks ring extensions for ANA, assign
trunks to Ring Groups (1 ~ 100), you make a
different entry for each Night Service mode.
Trunks 1 ~ 400
Incoming Group Number for
Day/Night Mode (1 ~ 8):
0 = (No Setting)
001 ~ 100 = (Incoming Group)
102 = (In-Skin/ External Voice
Mail or InMail)
103 = (Centralized VM)
DIL/IRG No Answer Destination
If a Universal Answer call rings longer than the
DIL No Answer Time (Program 22-01-04), it
routes to the Ring Group specified in this
option.
0 = (No Setting)
001 ~ 100 = Incoming Ring
Group
102 = (In-Skin/External Voice
Mail or InMail)
103 = Centralized VM
Universal Night Answer/Ring Over Page
For each Night Service Mode, assign which
trunks should ring which External Paging
Zones.
0 = No Ringing (No)
1 = Ringing (Yes)
To Next Page
Loading...
