NEC Univerge SV9100 - Page 991

991
Direct Inward Line (DIL)
Direct Inward System Access (DISA)
Line Preference
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
14-05-01
Trunk Group – Trunk Group Number
Assign Prime Line to a separate trunk group for
outgoing Prime Line selection. (Also refer to
Program 14-06 and Program 21-02.)
Trunk Port 1 ~ 400 =
Priority 1 ~ 400
Default = Trunks
1 ~ 400 assigned
to trunk group 1
with priorities
equal to the
trunk number.
Trunk 1 = Priority
1 Trunk 400 =
Priority 400.
14-06-01
Trunk Group Routing – Priority Order
Number
Set the priority order number 1 ~ 4.
0 = Not Specify
1 ~ 100: (Trunk Group Number)
101 ~ 150: (100 + Networking
System Number)
1001 ~ 1100: (1000 + Route
Table Number)
Route 1, Order
Number 1 = 1
(Trunk Group 1)
Order Numbers
2, 3, 4 = 0 (Not
Specified)
All Other Routes
(2 ~ 100) and
Order Numbers
(1 ~ 4) = 0 (Not
Specified)
14-07-01
Trunk Access Map Setup – Trunk Port
Number
For outgoing Prime Line selection, assign each
Prime Line trunk to a different Access Map and
deny outbound access to all trunks except the
Prime Line trunk.
0 = No access
1 = Outgoing access only
2 = Incoming access only
3 = Access only when trunk on
Hold
4 = Outgoing access and access
when trunk on Hold
5 = Incoming access and access
when trunk on Hold
6 = Incoming and Outgoing
access
7 = Incoming access, outgoing
access and access when trunk
on Hold
Trunk Access Maps: 1 ~ 400
Access Maps
1 ~ 400 = Trunk
Ports 1 ~ 400
assigned with
option 7 access
(incoming and
outgoing access
and access
when trunk is on
Hold).
15-01-02
Basic Extension Data Setup – Outgoing
Trunk Line Preference
Turn Off or On Outgoing Trunk Line Preference
for extensions.
0 = Off
1 = On
0
15-02-10
Multiline Telephone Basic Data Setup –
Ringing Line Preference for Trunk Calls
Enter 1 if lifting the handset should answer
ringing Prime Line; enter 0 to seize idle line
appearance.
0 = Idle (Off)
1 = Ringing (On)
1