1001 Bit Switch
005 Bit Switch 5 0 1
bit 0 DFU - -
bit 1 Multiple copies if a paper size or type mismatch
occurs
0:Disabled
(Single
copy)
1:Enabled
(Multiple
copy)
If a paper size or type mismatch occurs during the printing of multiple copies, only a
single copy is output by default. Using this bit switch, the device can be configured
to print all copies even if a paper mismatch occurs.
bit 2 Prevent SDK applications from altering the contents
of a job.
0:Disabled 1:Enabled
Enable: SDK applications will not be able to alter print data. This is achieved by
preventing SDK applications from accessing a module called the "GPS Filter".
Note: The main purpose of this bit switch is for troubleshooting the effects of SDK
applications on data.
bit 3 [PS] PS Criteria 0: Pattern3 1: Pattern1
Change the number of PS criterion used by the PS interpereter to determine whether
a job is PS data or not.
Pattern3: (2 to 4): The larger the pattern number, the greater the number of criterion
used. Pattern 4 includes most PS commands.
Pattern1: A small number of PS tags and headers
bit 4 Increase max. number of stored jobs. 0:Disabled
(100)
1:Enabled
(750)
Changes the maximum number of jobs that can be stored on the HDD. The default
(disabled) is 100. If this is enabled, the max. will be raised to 750 or 1000
depending on the model.
Printer Service Mode
247
To Next Page