Firmware type Partation Message display
SimpleScan Smart Operation Panel-CPU
board
M2a_SimpleScan
SmartCopy Smart Operation Panel-CPU
board
M2a_SmartCopy
SmartScan Smart Operation Panel-CPU
board
M2a_SmartScan
LanguageWidget Smart Operation Panel-CPU
board
M2a_WLanguage
• Even when not using a RPCS driver, the XPS driver requires RPCS firmware.
Procedure
• A SD card is a precision device, so when you handle an SD card, respect the following.
• When the power is switched ON, do not insert or remove a card.
• During installation, do not switch the power OFF.
• Since the card is manufactured to high precision, do not store it in a hot or humid location, or in
direct sunlight.
• Do not bend the card, scratch it, or give it a strong shock.
• Before downloading firmware on an SD card, check whether write-protection of the SD card is
canceled. If write-protection is enabled, an error code (error code 44, etc.) will be displayed
during download, and the download will fail.
• Before updating firmware, remove the network cable from this machine.
• If SC818 is generated during software update, switch the power OFF -> ON, and complete the
update which was interrupted.
• During software update, network cables, remove interface cables, wireless boards, etc., (so that
they are not accessed during update).
Update procedure
1. First download the software to be updated to the SD card.
2. Switch the power OFF.
5. System Maintenance Reference
594
To Next Page
Loading...
Need help?
General
