• Front cover must be down so that the cover sensor detects the front cover closed.
• Paper exit guide must be down so that the guide sensor detects that the guide down.
• Right covers must be attached so that the ink collector sensor detects that the cover is closed.
• Ink cartridge cover must be attached.
14. Open the ink cartridge cover and leave it open.
• The ink cartridge cover must be open so that you can complete this procedure.
• If the machine is powered on with the cover closed, the machine will start the initial filling
sequence and try to move the carriage unit to the home position for capping.
15. Turn on the machine.
16. Ignore the error.
17. Go into the SP mode and do SP2012-1. If the value of this SP code does not read "9", then
enter "9".
18. Confirm that all seven ink supply tubes are connected securely to the dummy tank.
19. Open SP2100-5, and then enter "31".
• The ink starts pumping from the ink cartridges, through the tubes and into the ink sump.
• When you see "Completed" the pumping operation is finished.
20. Turn the machine off.
21. Disconnect the ink supply tubes from the dummy tank.
22. Insert a metal plug into the end of each tube to prevent ink leakage.
Ink Tube Attachment to the Print Head Unit
Before attaching the bracket to secure the ink tubes, check that the ink tubes are lined correctly
as shown below.
4. Replacement and Adjustment
516
To Next Page
Loading...
Need help?
General
