Icon [1] This icon is lit when there is temporary data to be overwritten, and
blinks during overwriting.
Icon [2] This icon is lit when there is no temporary data to be overwritten.
HDD Encryption
Before You Begin the Procedure:
1. Make sure that the following settings (1) to (3) are not at the factory default settings.
(1) Supervisor login password
(2) Administrator login name
(3) Administrator login password
If any of these settings is at a factory default value, tell the customer these settings must be changed
before you do the installation procedure.
2. Confirm that "Admin. Authentication" is on: [User Tools] -> [Machine Features] - [System
Settings] - [Administrator Tools] - [Administrator Authentication Management] - [Admin.
Authentication] - [On]
If this setting is off, tell the customer that this setting must be on before you can do the installation
procedure.
3. Confirm that "Administrator Tools" is selected and enabled.
[User Tools] -> [Machine Features] - [System Settings] - [Administrator Tools] - [Administrator
Authentication Management] - [Available Settings]
"Available Settings" is not displayed until step 2 is done.
If this setting is not selected, tell the customer that this setting must be selected before you can do the
installation procedure.
Enable Encryption Setting
Machine Data Encryption Settings can be enabled by the following procedure.
Setting Up Encryption
Security Setting
179
To Next Page
Loading...
Need help?
General
