NVRAM Data Upload/Download
Uploading Content of NVRAM to an SD card
Do the following procedure to upload SP code settings from NVRAM to an SD card.
• This data should always be uploaded to an SD card before the NVRAM is replaced.
• Make sure that the write protection of an SD card is unlocked.
1. Do SP5-990-001 (SP Print Mode: All (Data List)) before you switch the machine off. You
will need a record of the NVRAM settings if the upload fails.
2. Switch the copier main power switch off.
3. Remove the SD slot cover [A]. ( × 1)
5. System Maintenance Reference
630
To Next Page
Loading...
