Waste Ink Collection
Ink Collector Tank
1. Open the ink collector cover on the right side of the machine.
2. Depress the release [A], and then pull the tank straight out of the machine.
3. Lay the tank on a flat surface with the port [B] facing up.
• The port at [B] is open and will leak ink if the tank is turned on its side or turned upside
down. Tape the port to prevent leakage.
Right Ink Sump
Replace the right ink sump when a message alerts you that the tank is full.
1. Remove the ink collector unit on the right side of the machine.
2. Remove the ink collector cover and right cover (p.239).
3. Disconnect the sump and pull it out slowly ( x1).
• To avoid spilling ink, do not tilt the sump as you remove it.
PM Cleaning Points
199
To Next Page
Loading...
