Printable Conditions
• Only color ink runs out.
• During monochrome printing, ink used for air purging of an ink head for which ink has run out
remains in the head tank.
• The air-mixed flag is not set for the heads, including those with ink end.
Reason: If the air-mixed flag is set, ink volume in the head tank cannot be determined correctly, in
which case emergency stop of printing because ink consumption cannot be performed.
• Ink cartridges are mounted at all ink-cartridge ports.
• The ink-cartridge cover is closed.
• Color ink end is not caused by maintenance operations.
Printing
The display shown below appears during copying/printing operation.
"The color ink ends. For color printing, change the cartridges.
Monochrome printing is temporarily enabled. If there is a print job being performed, reset it. Then
perform the monochrome printing."
• Monochrome printing can be continued by touching [Print].
• Color printing can be continued by resetting the current print job then starting monochrome printing
again.
Conditions for Function End
If the conditions below are applied, the machine exit Emergency Print mode.
• When three days have passed after entering Emergency Print mode, (SP No.: SP2-802-003 to
-007)
* When emergency printing ends and the ink-end display appears, reset the corresponding SPs
(SP2-802-003 to -007, SP2-80l-003 to -007).
• When the specified ink has been consumed with air purging for the color whose ink ends,
If the machine judges itself to be exited Emergency Print mode, the machine stops, Emergency Print
mode is canceled, and the ink-end display appears.
Printing cannot be performed until the empty ink cartridge is replaced.
Number of Printable sheets
• Room temperature and humidity: 34
7. Detailed Description
838
To Next Page
Loading...
Need help?
General
