• In this model, note that the LEDs are not as close to the USB cable as usual.
2. Disconnect the power cord
3. Wait 3 minutes. This is the time required if you intend to remove the rear cover and service parts in
the machine, like removal of the controller board, for example).
• If some LEDs on any of the boards are blinking or lit, current is still flowing.
• After the shutdown process, the main power is turned off automatically.
When the shutdown is complete
Main power LED: Off
Operation panel LED: Off
• How to start from shutdown
• To start the machine, press the main power switch. However, if you press the main power switch
between the beginning and the end of a shutdown, the machine will not start.
Notes on the Main Power Switch
215
To Next Page
Loading...
