Ricoh MP CW2201

4. Make sure that the SD card access LED is off, then remove the SD card.
• If ‘failed’ appears on the touch panel display, turn the power off, and then recover from step
1 again.
The debug logs are saved with the following file names.
Controller debug log (GW debug
log)
/LogTrace/[Machine Serial]/watching/
[yyyymmdd_hhmmss]_[UniqueID].gz
Engine debug log
/LogTrace/[Machine Serial]/engine/
[yyyymmdd_hhmmss].gz
FCU debug log
/LogTrace/[Machine Serial]/fculog/
[yyyymmdd_hhmmss].gz
Capturing the Debug Logs
627