SC211-01 D Carriage Communication Error
No response from the motor control firmware
Communication error between the motor control firmware and engine. The
machine failed to stop within the specified time and area because of the
mechanical trouble.
Communication Error
• Cycle the machine off/on
• If the problem recurs, check around the HRB on the carriage unit for a
loose, broken, or defective connector
• Check around the MCU for a loose broken connector on a harness from
the carriage unit.
• Replace BICU.
Mechanical Trouble
• Check that there is no problem with the driving parts (guide, rod, roller,
gear, belt).
• If the belt is loose, tighten the belt.
• If it is not recovered by turning the power OFF/ON, replace the parts.
SC200: Image Writing
669
To Next Page
Loading...
