SC211-04 D Main scan motor driver error (overcurrent)
Response to a motor driver error (overcurrent) from motor control
This error is issued when the motor driver is in overcurrent status.
• Check that there is no problem with the driving parts (guide, rod, roller,
gear, belt).
• Check that there is no problem with sliding.
• Replace the BICU.
SC211-05 D Main Scan Motor Driver Error (Overheating)
Response to a motor driver error (overheating) from motor control
This error is generated when the motor driver is in overheating status.
• Check that there is no problem with the driving parts (guide, rod, roller,
gear, belt).
• Check that there is no problem on sliding.
• Check that there is no abnormal odor, smoke, or fire.
• Replace the BICU.
SC211-06 D Main Scan Motor Driver Error (Low Voltage)
Response to a motor driver error (overheating) from motor control
This error is generated when the motor driver is in overheating status.
If it is not recovered by turning the power OFF and back ON, replace the
BICU.
SC200: Image Writing
671
To Next Page
Loading...
