Ricoh MP CW2201

SC250-02 B Auto-Nozzle Check Prohibit (Electrode Wiping)
The auto-nozzle check prohibit flag is set to ON.
• Wiper position detection (at the far end) sensor defective
• Electrode wiping motor defective
• Remove any foreign matter.
• Replace the wiper position detection (at the far end) sensor
• Replace the electrode wiping motor
• Replace the auto-nozzle check unit
SC250-03 B Auto-Nozzle Check Life
The auto-nozzle check unit ends its service life.
• Do a auto-nozzle check
• After replacing the auto-nozzle check unit, do SP2-020-004.
SC252-01 D Electrode Wiping Return Position Error
If the wipe position detection (Home position) sensor is Low before starting
return
• Wipe position detection (Home position) sensor defective
• Remove the foreign matter.
• Replace the wipe position detection (Home position) sensor
• Replace the auto-nozzle check unit.
SC200: Image Writing
673