SC283 D Ink End Detection Error
The mechanical ink end sensor has failed, or one of the ink supply pumps has
failed.
SC283-01 D Ink end detection error tank 1
SC283-02 D Ink end detection error tank 2
SC283-03 D Ink end detection error tank 3
SC283-04 D Ink end detection error tank 4
SC283-05 D Ink end detection error tank 5
SC283-06 D Ink end detection error tank 6
SC283-07 D Ink end detection error tank 7
SC283-08 D Ink end detection error tank 3 & 4
SC283-09 D Ink end detection error tank 6 & 7
• Cycle the machine off/on
• Ink end sensor defective
• Replace ink supply unit
SC285-00 C DRESS Sensor Calibration Error
Detection conditions:
1. The reflected beams was measured less than 400 when the head gap was
adjusted automatically.
2. When the sensor output is lower than 4.0 V with the magnification register
ON and in Full Duty for calibration of the image registration.
• DRESS sensor harness loose, broken, defective
• DRESS sensor defective
• Common to 1 and 2: Sensor trouble, such as sensor defective, loose
connection (CN11)
• Only 1: Not-recommended paper used (dark color or pattern printed)
6. Troubleshooting
676
To Next Page
Loading...
