SC686-43 C Ink Cartridge (K): Device Error (No ACK Signal)
There was an error in communication with the ID Chip on the Black ink
cartridge. Three retries were attempted and failed.
• Ink cartridge ID data corrupted or chip damaged
• Spurious noise
• Cycle the machine off/on
• Remove the Black ink cartridge and set it again
• Switch the machine on
• If the problem persists, replace the Black ink cartridge
• Insert and remove the ink-cartridge.
• Replace the ink-cartridge.
• Check whether foreign matter is attached to the ID chip of the ink
cartridge or not. If so, remove it.
• Check whether foreign matter is pinched with or attached to the ID chip
terminal of the ink cartridge holder (insertion section on the main unit) or
not. If so, remove it.
• Check whether the ID chip terminal of the ink cartridge holder (insertion
section on the main unit) is defective, such as being deformed, or not. If
so, replace the service part module.
• If an error is generated after removing the exterior for repairing the
machine, check that the connectors are correctly connected upon repair.
If some trouble is found, correct it.
SC687-00 D PER command error
The main machine received no PER-command module from the GW
controller.
• Poor communication, cycle the machine power off/on
SC600: Communication
705
To Next Page
Loading...
Need help?
General
