(e) Verifying point table data (e)
Click "Verify" to verify all the data displayed and data of the driver.
(f) Detailed setting of point table data (f)
Click "Detailed Setting" to change position data range and unit in the point table window. Refer to (2)
in this section for details.
(g) Single-step feed (g)
Click "Single-step Feed" to perform the single-step feed test operation. Refer to section 4.5.1 (1) (e)
for details.
(h) Copy and paste of point table data (h)
Click "Copy" to copy the selected point table data. Click "Paste" to paste the copied point table data.
(i) Inserting point table data (i)
Click "Insert" to insert a block before the selected point table No. The selected block and later will be
shifted down by one.
(j) Deleting point table data (j)
Click "Delete" to delete the selected block of the point table No. The selected block and later will be
shifted up by one.
(k) Changing point table data (k)
After selecting the data to be changed, enter a new value, and click "Enter". You can change the
displayed range and unit with (1) (f) "Detailed setting of point table data" in this section.
(l) Reading point table data (l)
Click "Open" to read the point table data.
(m) Saving point table data (m)
Click "Save As" to save the point table data.
(n) Updating project (n)
Click "Update Project" to update the point table data to a project.
To Next Page
Loading...
