Xerox Phaser 4510 - Cleaning the Printer

3-22 Phaser 4500/4510 Service Manual
Error Messages and Codes
“Fuser Failure\ Press i” Fuser Low Temp
U4-2: Fuser Fail/Power
Off
1—Go to
page 3-30.
“Fuser Failure\ Press i” Fuser Overheat in
Stand-by
U4-3: Fuser Fail/Power
Off
1—Go to
page 3-30.
“Fuser Failure\Press i” Fuser Fails at warm-up
U4-4: Fuser Fail/
Power Off
1—Go to
page 3-30.
“Fuser Failure\Press i” Fuser Thermistor
Failure
U4-5: Fuser Fail/
Power Off
1—Go to
page 3-30.
“Toner Is Low\ Press i” J5: Toner Low — — Go to
“Toner
Sensor” on
page 4-22
“Fan Failure\ Power Off
Now\ Press i”
U5: Fan Fail/ Power Off 0 — Go to
page 3-31.
“Install Or Reseat print
cartridge\ Press i”
J3: Missing Print
Cartridge
——Go to
page 3-61.
“Replace Print Cartridge\
Press i”
———Go to
page 3-62.
“Close Top Cover\
Press i”
Top Cover Open — — Go to
page 3-58.
“Close Rear Cover\
Press i”
Rear cover open — — Go to
page 3-58.
“Jam At Tray N; Remove
Trays And Open Top
Cover To Clear\ Press i “
E2-01 Feed Jam
E2-02 Feed Jam
E2-03 Feed Jam
E2-04 Feed Jam
—1
2
3
4
Go to
page 3-34.
“Jam At Tray N; Remove
Trays And Open Top
Cover To Clear\ Press i “
E2-11 Feed Jam
E2-12 Feed Jam
E2-13 Feed Jam
E2-14 Feed Jam
—1
2
3
4
Go to
page 3-37.
“Jam At Top; Open Top
Cover To Clear\ Press i”
E3-1 Reg. Jam
E3-2 Reg. Jam
—6Go to
page 3-40.
“Jam At Exit; Open Rear
Cover To Clear\ Press i”
E4-2 Exit Jam — 5 Go to
page 3-43.
“Jam At Exit; Open Rear
Cover To Clear\ Press i”
E4-3 Exit Jam — 5 Go to
page 3-43.
“Jam At Exit; Open Top
Cover To Clear\ Press i”
E4-0 Exit Jam — 5 Go to
page 3-43.
Phaser 4500 Error Message Summary
Control Panel Message Diagnostic Message
Engine
Errors
Jam
Errors
Procedure
to Use