Xerox Phaser 4510 - Page 102

3-24 Phaser 4500/4510 Service Manual
Error Messages and Codes
“Maintenance Kit is Near
End of Life\ Press i”
N/A — — —
“Replace Maintenance
Kit”
N/A — — Go to
page 3-71.
“Stacker Is Full, Unload
Paper\ Press i”
Stacker output tray full — — Go to
page 3-69
“Standard Output Tray Is
Full, Unload Paper\
Press i”
Output tray full — — Go to
page 3-70
“Tray 3 Failure\ Press i” E11-1 Tray 3 unit fail — 6 Go to
page 3-54
“Tray 3 or 4 Failure\
Press i”
E11-2 Tray 3 or 4 unit
fail
—7Go to
page 3-54
“Duplex Unit Failure\
Press i”
E9-1 Duplex unit fail — 8 Go to
page 3-52.
“Stacker Unit Failure\
Press i”
E9-2 Stacker unit fail — 4 Go to
page 3-53.
“Close Duplex Unit
Cover\ Press i”
Duplex cover open — — Go to
page 3-59.
“Close Stacker cover\
Press i”
Stacker cover open — — Go to
page 3-60.
“Invalid Configuration
Card\ Press i”
N/A — — —
“Configuration Card
Missing\ Press i”
N/A — — —
Phaser 4500 Error Message Summary
Control Panel Message Diagnostic Message
Engine
Errors
Jam
Errors
Procedure
to Use