Xerox Phaser 4510 - Page 381

Phaser 4500/4510 Service Manual 8-101
FRU Disassembly
Procedure:
1. Remove the left cover (page 8-96).
2. Remove the right cover (page 8-97).
3. Unplug J50, the duplex unit harness, from P50 on the duplex unit PWBA.
4. Remove the 6 mm machine screw to disconnect the duplex unit ground
wire.
5. Release the duplex unit harness and ground wire from the harness clamp.
6. Remove the shoulder screw that attaches the damper spring.
7. Remove the two hinge screws that secure the duplex unit lower housing,
and remove the duplex unit lower housing from the duplex unit housing
cover.
1.Duplex unit ground wire 3.Duplex unit motor
2.Duplex unit harness 4.Duplex unit sensor harness
2
4
3
1
s4510-187
1
2
3
4
P4500
P4510