Wireless Access Point
Configuring the Wireless AP 285
25. Use Date off to specify a date to take the SSID out of service without
deleting it. At the specified date, the AP will turn the Enabled flag off.
Leave Expiration and Date off set to none (the default) if you want this
SSID to remain in service indefinitely after its scheduled start. Use
Specific Date & Time to take the SSID out of service at the specified date
and time. Use the format YYYY-MM-DD [HH:MM], where time (hour
and minute) is optional. For example, enter 2016:09:29 18:00. Use After
Duration to keep the SSID in service for the specified amount of time in
days, hours, and minutes (use the format DD [HH:MM], where hours and
minutes are optional).
26. Use Expiration to specify a date to delete this SSID when it is taken out of
service at the specified date (i.e., this option cleans up after itself when it
reaches the expiration time). Leave Expiration and Date off set to none
(the default) if you want this SSID to remain in service indefinitely after
its scheduled start. Use Specific Date & Time to delete the SSID at the
specified date and time. Use the format YYYY-MM-DD [HH:MM], where
time (hour and minute) is optional. For example, enter 2016:09:29 18:00.
Use After Duration to keep the SSID in service for the specified amount
of time in days, hours, and minutes (use the format DD [HH:MM], where
hours and minutes are optional).
27. Web Page Redirect Configuration: see “Web Page Redirect (Captive
Portal) Configuration” on page 286.
28. To delete an SSID, click its Delete button .
29. Click the Save button if you wish to make your changes permanent.
To Next Page
Loading...
Need help?
General
