ABB AC500 V3 - Page 61

1. In the device tree, double-click the desired option board.
2. Select the “TA51xx Parameters” tab to edit the parameterization of the desired option
board.
1. In the device tree, double-click the desired option board.
2. Select the “Diagnosis” tab to view the diagnosis messages of the desired option board.
Table 27: Diagnosis messages
Device Severity Error
code
Description
Error Message Remedy
TA5105-4DOT 11 1 Wrong or no board
plugged
Replace with correct func-
tional board
TA5105-4DOT 11 2 Board defective Replace with correct func-
tional board
TA5105-4DOT 11 3 Failed to set direction Replace with correct func-
tional board
TA5105-4DOT 11 4 Parameter wrong Verify setting of parameter
“Run on config fault”
Diagnosis
Device specifications
Processor modules > AC500-eCo
2022/01/31 3ADR010278, 3, en_US 61