Agilent Technologies N1911A Programming Guide

2 MEASurement Commands
134 N1911A/1912A P-Series Power Meters Programming Guide
Example
Error Messages
• INITiate:CONTinuous must be set to OFF, otherwise error –213, “INIT
ignored” occurs.
•If TRIGger:SOURce is set to BUS or HOLD, error –214, “Trigger
deadlock” occurs.
• If the expected value and resolution parameters are not the same as
the current expected value and resolution settings on the specified
window, error –221, “Settings conflict” occurs.
READ1:REL? DEF,1,(@2) This command queries the upper
window/upper measurement relative
measurement of Channel B, using the
current sensor range and a resolution of
1.

Agilent Technologies N1911A Specifications

General

Brand	Agilent Technologies
Model	N1911A
Category	Measuring Instruments
Language	English