EasyManuals Logo

Agilent Technologies N1911A Programming Guide

Agilent Technologies N1911A
803 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #203 background imageLoading...
Page #203 background image
CALCulate Subsystem 3
N1911A/1912A P-Series Power Meters Programming Guide 175
Example
Reset Condition
On reset, both windows and their measurements are set to ON.
Query
CALCulate[1]|2|3|4:LIMit:CLEar:AUTO?
The query command enters a 1 or 0 into the output buffer indicating
whether limit failures are cleared automatically when a new measurement
is initiated on the specified window section.
• 1 is entered into the output buffer when limit failures are cleared
automatically when a new measurement is initiated.
• 0 is entered into the output buffer when limit failures are not cleared
automatically when a new measurement is initiated.
In the case where limit failures are cleared once, when a query occurs a 1
is entered into the output buffer if no measurement is initiated. If a
measurement is initiated then 0 is entered.
Query Example
CALC1:LIM:CLE:AUTO 1 This command switches on automatic
clearing of the FCO for the upper
window/upper measurement.
CALC1:LIM:CLE:AUTO? This command queries when the FCO is
cleared for the upper window/upper
measurement.

Table of Contents

Other manuals for Agilent Technologies N1911A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies N1911A and is the answer not in the manual?

Agilent Technologies N1911A Specifications

General IconGeneral
BrandAgilent Technologies
ModelN1911A
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals