4 CALibration Subsystem
210 N1911A/1912A P-Series Power Meters Programming Guide
Query Example
Error Messages
When CAL[1]|2:RCAL is ON and the sensor currently connected to the
appropriate channel (A or B) has not been zeroed and calibrated, then any
SCPI command which would normally return a measurement result (for
example, FETC?, READ?, MEAS? etc) does not return a result and generates
the error –230, “Data corrupt or stale; Please zero and Cal.”
After the sensor has been zeroed and calibrated the return measurement
results commands function normally.
CAL1:RCAL? This command queries whether or not the
zero/cal lockout facility is enabled for
Channel A.
To Next Page
Loading...
