MEMory Subsystem 7
N1911A/1912A P-Series Power Meters Programming Guide 267
Syntax
Parameters
Example
Error Messages
If the table or save/recall register name does not exist, error –224, “Illegal
parameter value” occurs.
Item Description/Default Range of Values
character_data Contains an existing table name or
save/recall register.
Any existing table name or
save/recall register.
MEM:CLE "8485A" This command clears the contents of
sensor calibration table 8485A.
MEM
:CLE :NAME
Space
character_data
To Next Page
Loading...
