9 PSTatistic Subsystem
318 N1911A/1912A P-Series Power Meters Programming Guide
Example
Reset Condition
On reset, the marker 1 and marker 2 will be set back to their default
positions.
Error Messages
• If command is executed in other window besides CCDF window, error
–221 “Settings conflict: Requires CCDF window” occurs.
• If the requested X position is more than max dB then error –220
"Parameter error" occurs.
• If invalid parameter choice has been used then error –224 “Illegal
parameter value” occurs.
PST:CCDF:MARK1:X 20 This command sets marker 1 to the
position where the X- axis is 20 dB.
To Next Page
Loading...
Need help?
General
