9 PSTatistic Subsystem
320 N1911A/1912A P-Series Power Meters Programming Guide
Example
Reset Condition
On reset, the marker 1 and marker 2 will be set back to their default
positions.
Error Messages
• If command is executed in other window besides CCDF window, error
–221 “Settings conflict: Requires CCDF window” occurs.
• If the requested Y position is more than 100 or less than 0 then error
–220 "Parameter error" occurs.
• If invalid parameter choice has been used then error –224 “Illegal
parameter value” occurs.
PST:CCDF:MARK1:Y 20 This command sets marker 1 to the
position where the Y- axis is 20 %.
To Next Page
Loading...
Need help?
General
