SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 375
Reset Condition
On reset, the filter length is set to 4.
Query
AVERage2:COUNt?
The query returns the current setting of the video filter length. The format
of the response is <NR1>.
Query Example
Error Messages
• If the command is used when a sensor other than a P- Series or E9320
power sensor is connected, error –241, “Hardware missing” occurs
• If the command is used when an E9320 sensor is connected and set to
AVERage mode rather than NORMal mode, the error –221, “Settings
Conflict” occurs.
AVER2:COUN? This command queries the video filter
length for Channel A.
To Next Page
Loading...
Need help?
General
