SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 431
Reset Condition
On reset, autoranging is enabled.
Query
[SENSe[1]]|SENSe2:POWer:AC:RANGe:AUTO?
The query enters a 1 or 0 into the output buffer indicating the status of
autoranging.
• 1 is returned when autoranging is enabled
• 0 is returned when autoranging is disabled
Query Example
Error Messages
• If this command is set to OFF when there is not an E- Series power
sensor or N8480 Series power sensor (excluding Option CFT) connected,
the error –241, “Hardware missing” occurs.
• If this command is set to ON when E9320 power sensor is in Normal
and Triggered modes, the error - 221, “Setting conflicts” occurs.
POW:AC:RANG:AUTO? This command queries whether auto
ranging is on or off.
To Next Page
Loading...
