10 SENSe Subsystem
448 N1911A/1912A P-Series Power Meters Programming Guide
Reset Condition
On reset, the duration is set to 100 µs.
Query
SENSe[1]]|SENSe2:TRACe:TIME?
The query returns the current duration of the trace.
Query Example
Error Messages
• If the command is used when a sensor other than a P- Series or E9320
power sensor is connected, error –241, “Hardware missing” occurs
• If the command is used when an E9320 sensor is connected and set to
AVERage mode rather than NORMal mode, the error –221, “Settings
Conflict” occurs.
SENS2:TRAC:TIME? This command queries the current
duration of the trace.
To Next Page
Loading...
Need help?
General
