EasyManuals Logo

Agilent Technologies N1911A Programming Guide

Agilent Technologies N1911A
803 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #547 background imageLoading...
Page #547 background image
SYSTem Subsystem 12
N1911A/1912A P-Series Power Meters Programming Guide 519
–168 Block data not allowed
A legal block data element was encountered but not allowed by the power meter at
this point.
For example SYST:LANG #15FETC?.
–178 Expression data not allowed
A legal expression data was encountered but not allowed by the power meter at
this point.
For example SYST:LANG (5+2).
–211 Trigger ignored
Indicates that <GET> or *TRG, or TRIG:IMM was received and recognized by the
device but was ignored because the power meter was not in the wait for trigger
state.
–213 Init ignored
Indicates that a request for a measurement initiation was ignored as the power
meter was already initiated.
For example, INIT:CONT ON
INIT.
–214 Trigger deadlock
TRIG:SOUR was set to HOLD or BUS and a READ? or MEASure?
was attempted, expecting TRIG:SOUR to be set to IMMediate.
–220 Parameter error;Frequency list must be in ascending order.
Indicates that the frequencies entered using the
MEMory:TABLe:FREQuency command are not in ascending order.
–221 Settings conflict
This message occurs under a variety of conflicting conditions. The following list
gives a few examples of where this error may occur:
If the READ? parameters do not match the current settings.
If you are in fast mode and attempting to switch on for example,
averaging, duty cycle or limits.
Trying to clear a sensor calibration table when none is selected.
–222 Data out of range
A numeric parameter value is outside the valid range for the command.
For example, SENS:FREQ 2KHZ.
–224 Illegal parameter value
A discrete parameter was received which was not a valid choice for the command.
You may have used an invalid parameter choice.
For example, TRIG:SOUR EXT.

Table of Contents

Other manuals for Agilent Technologies N1911A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies N1911A and is the answer not in the manual?

Agilent Technologies N1911A Specifications

General IconGeneral
BrandAgilent Technologies
ModelN1911A
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals