To Next Page

To Previous Page

TRACe Subsystem 13

N1911A/1912A P-Series Power Meters Programming Guide 625

Error Messages

• If a P- Series sensor is not connected, error –241, “Hardware missing”

occurs.

• If a P- Series sensor is connected and Free Run trigger acquisition is

selected, error –221, “Settings conflict” occurs.

NOTE

TIf you attempt to measure a pulse out of the range of the capture, for example, measure

the 5th pulse and there are only 4 pulses displayed, the power meter returns #0##9.91E37

as the result.

Agilent Technologies N1911A Programming Guide

Other manuals for Agilent Technologies N1911A