643
N1911A/1912A P-Series Power Meters
Programming Guide
Agilent Technologies
14
TRIGger Subsystem
TRIGger Subsystem 644
ABORt[1]|2] 646
INITiate Commands 647
INITiate[1]|2:CONTinuous <boolean> 648
INITiate[1]|2[:IMMediate] 651
INITiate:CONTinuous:ALL <boolean> 652
INITiate:CONTinuous:SEQuence[1]|2 <boolean> 654
INITiate[:IMMediate]:ALL 656
INITiate[:IMMediate]:SEQuence[1]|2 657
TRIGger Commands 658
TRIGger[1]|2:DELay:AUTO <boolean> 659
TRIGger[1]|2[:IMMediate] 661
TRIGger[1]|2:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2] 662
TRIGger[:SEQuence]:DELay <numeric_value> 665
TRIGger[:SEQuence]:HOLDoff <numeric_value> 667
TRIGger[:SEQuence]:HYSTeresis <numeric_value> 669
TRIGger[:SEQuence]:LEVel <numeric_value> 671
TRIGger[:SEQuence]:LEVel:AUTO <boolean> 673
TRIGger[:SEQuence]:SLOPe <character_data> 675
TRIGger[:SEQuence[1]|2]:COUNt <numeric_value> 677
TRIGger[:SEQuence[1]|2]:DELay:AUTO <boolean> 680
TRIGger[:SEQuence[1]|2]:IMMediate 682
TRIGger[:SEQuence[1]|2]:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2] 683
This chapter explains how the TRIGger command subsystem is used to
synchronize device actions with events.
To Next Page
Loading...
