15 SERVice Subsystem
714 N1911A/1912A P-Series Power Meters Programming Guide
Query
SERVice:SENSor[1]|2:CORRections:STATe?
The query enters a 1 or 0 into the output buffer indicating the status of
the voltage to corrected power conversion.
• 1 is returned when voltage to corrected power conversion is enabled
• 0 is returned when voltage to corrected power conversion is disabled
Query Example
Error Messages
•If INIT:CONT is not set to off, error –221, “Settings conflict” occurs.
• If the command is used when a sensor other than an E9320 power
sensor is connected, error –241, “Hardware missing” occurs.
SERV:SENS:CORR:STAT? This command queries whether voltage to
corrected power conversion is enabled for
Channel A.
To Next Page
Loading...
Need help?
General
