Digi IX20

Interfaces WideArea Networks(WANs)
IX20 User Guide
102
n
modem_power_cycle: This recovery action is available for WWAN interfaces only.
If modem_power_cycle is selected, complete the following:
l
Set the number of attemptsfor this recovery action to perform, before moving
to the next recovery action:
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
l
Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config network interface my_wan surelink actions 0)>
override_interval int
(config network interface my_wan surelink actions 0)>
n
reboot_device.
If reboot_device is selected, complete the following:
l
Set the number of attemptsfor this recovery action to perform, before moving
to the next recovery action:
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
l
Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config network interface my_wan surelink actions 0)>
override_interval int
(config network interface my_wan surelink actions 0)>
n
custom_action: Execute custom recovery commands.
If custom_action is selected, complete the following:
l
Set the number of attemptsfor this recovery action to perform, before moving
to the next recovery action:
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
l
Set the commandsto run to attempt to recovery connectivity.