MPC5553/MPC5554 Microcontroller Reference Manual, Rev. 5
B-8 Freescale Semiconductor
B.7 Revision History
Table B-3. Changes added to MPC5553/5554 RM for Rev. 4.0 Release
Description of Change
•In Section B.2, “Calibration Bus,” changed the following:
From: The four chip selects, CAL_CS[0:3], have a higher priority in address decoding than the non-calibration chip selects,
CS[0:3].
To: “In the MPC5553, the calibration chip selects CAL_CS[n], have a higher priority in address decoding than the
non-calibration chip selects, CS[n].”
• Changed CS1 to CAL_CS1 in the last paragraph of Section B.2, “Calibration Bus.”
• Ta ble B -1 Added FEC_ to the ethernet signals. Removed the footnote saying Data[16:31] signals for MPC5553 are alternate
signals. Corrected WE and BE bit settings for the MPC5554 from WE[0:1]_BE[64:65]_GPIO[64:65] to
WE/BE[0:1]_GPIO[64:65].
• Ta ble B -1 Added CAL_ADDR[10:11] and CAL_TA
to calibration signals
Table B-4. Changes added to MPC5553/5554 RM for Rev. 5.0 Release
Description of Change
No change for Rev. 5 release.
To Next Page
Loading...