Lenze i550 - 3-Phase Mains Connection 400 V (7.5-132 kW)

2 Safety instrucons
Disregarding the following basic safety measures and safety informaon may lead to severe
personal injury and damage to property!
Observe all specicaons of the corresponding documentaon supplied. This is the precondi-
on for safe and trouble-free operaon and for obtaining the product features specied.
Please observe the specic safety informaon in the other secons!
2.1 Basic safety instrucons
Personnel
The product must only be used by qualied personnel. IEC 60364 or CENELEC HD 384 dene
the skills of these persons:
•
They are familiar with installing, mounng, commissioning, and operang the product.
•
They have the corresponding qualicaons for their work.
•
They know and can apply all regulaons for the prevenon of accidents, direcves, and
laws applicable at the place of use.
Process engineering
The procedural notes and circuit details described are only proposals. It is up to the user to
check whether they can be adapted to the parcular applicaons. Lenze does not take any
responsibility for the suitability of the procedures and circuit proposals described.
2.2 Applicaon as directed
•
The product must only be operated under the operang condions prescribed in this doc-
umentaon.
•
The product meets the protecon requirements of 2014/35/EU: Low-Voltage Direcve.
•
The product is not a machine in terms of 2006/42/EU: Machinery Direcve.
•
Commissioning or starng the operaon as directed of a machine with the product is not
permied unl it has been ensured that the machine meets the regulaons of the EU
Direcve 2006/42/EU: Machinery Direcve; observe EN 60204−1.
•
Commissioning or starng operaon as directed is only permissible if the EMC Direcve
2014/30/EU is complied with.
•
The harmonised standard EN 61800−5−1 is applied.
•
The product is not a household appliance, but is only designed as a component for com-
mercial or professional use in terms of EN 61000−3−2.
•
The product can be used according to the technical data if drive systems have to comply
with categories according to EN 61800−3.
In residenal areas, the product may cause EMC interferences. The operator is responsible
for taking interference suppression measures.
•
The product must only be actuated with motors that are suitable for the operaon with
inverters.
-
Lenze L-force motors meet the requirements
-
Excepon: m240 motors are designed for mains operaon only.
Safety instrucons
Applicaon as directed
18