Lenze i550

12.3 Further mappable parameters
The parameters listed in the following can also be mapped to network registers to transmit,
for example, control and status informaon as process data or to control outputs of the inver-
ter via the network.
•
The parameters are always available irrespecve of the network opon.
•
The use of these parameters for the transmission of process data is oponal. It is also pos-
sible to use only a selecon of the parameters.
Process input data
Address Designaon Info
0x400B:011
(P592.11)
Process input data: PID feedback
4Feedback of PID variable via network^ 302
0x4008:002
(P590.02)
Process input words: NetWordIN2
4Control digital outputs via network^ 302
0x4008:003
(P590.03)
Process input words: NetWordIN3
4Control analog outputs via network^ 302
0x4008:004
(P590.04)
Process input words: NetWordIN4
0x4008:005
(P590.05)
Process input words: NetWordIN5
4Addive voltage impression via network^ 303
Process output data
Address Designaon Info
0x400C:005
(P593.05)
Process output data: Drive status
4Drive status^ 304
0x2C49:003
(P711.03)
Posion counter: Actual posion
4Posion counter^ 538
0x400A:002
(P591.02)
Process output words: NetWordOUT2
4Output messages of the "sequencer" funcon via network^ 304
Conguring the network
Further mappable parameters
301