Lenze i550

16.2.2.1 Reseng WLAN sengs to default seng
Possible reasons:
•
Password is not known anymore.
•
WLAN SSID is not visible and not known anymore.
•
WLAN module mode "stand-alone" shall be deacvated.
0x2440 serves to reset all WLAN sengs to the default seng. For this purpose, the inverter
must be connected to the »EASY Starter« via the USB module or an exisng network.
Opon 1: Reset via USB module
How to reset the WLAN sengs to default seng by means of the USB module:
Requirements:
•
The inverter is ready for operaon (supplied with voltage).
Required accessories:
•
USB module
•
USB 2.0 cable (A-plug on micro B-plug)
•
PC with installed »EASY Starter« soware
1.Remove the WLAN module from the inverter and plug in the USB module instead.
2.Establish a connecon between inverter and »EASY Starter« via the USB module.
3.Set the parameter 0x2440 to "Restart with default values [2]".
4.Remove the USB module from the inverter and plug in the WLAN module instead again.
The default seng is loaded.
Opon 2: Reset via network
How to reset the WLAN sengs to default seng via network:
Requirements:
•
The inverter is ready for operaon (supplied with voltage).
•
The inverter is connected to a funconing network.
Required accessories:
•
PC with installed »EASY Starter«. Moreover, the PC must be connected to the network
which also implements the inverter.
1.Establish a connecon between the inverter and »EASY Starter« via the used network.
2.Set the parameter 0x2440 to "Restart with default values [2]".
The default seng is loaded.
Using accessories
WLAN module
WLAN basic sengs
585